Explore measured drone and bird radar recordings, select 8–256 FIR taps and tune low-pass or band-pass responses. Inspect recorded results immediately; activate the protected trial to run your configuration.
This lab runs selectable symmetric FIR configurations. Its animation, target range and speed are illustrative models; the spectrum uses software DFT. Full radar, joint ISAC, autonomy, FPGA timing and silicon qualification remain separate.
Share sample rate, word widths, interfaces, target device and acceptance workload. Delivery is quoted after configuration review.
Discuss configuration Explore applicationsIdentical recorded drone input, 24% low-pass cutoff and no clock stalls. The tap counts implement different filter responses. Zero history at reset includes startup transients. Clock counts are measured in simulation; FPGA MHz, resources and silicon qualification are separate.
| Taps | First output (clocks) | Output gap (clocks) | Checked samples | Mismatches |
|---|---|---|---|---|
| 8 | 8 | 1 | 256 | 0 |
| 16 | 12 | 1 | 256 | 0 |
| 32 | 20 | 1 | 256 | 0 |
| 64 | 36 | 1 | 256 | 0 |
| 128 | 68 | 1 | 256 | 0 |
| 256 | 132 | 1 | 256 | 0 |
Independent MATLAB fir1/filter comparison: 132 configurations, 33,792 output values, zero coefficient or output mismatches. This checks numerical correctness; it does not measure FPGA timing.